The 74101-169-62 printed circuit board (PCB) kit is a 460 Volts AC rated PCB spare part kit from Allen-Bradley. It has a power output rating of 600 Horsepower. This spare part kit is a gate drive PCB kit. It is compatible with all the Allen-Bradley 1336 series adjustable frequency drives. It fits in perfectly with all the drives with frame sizes A, B, C, D, and E. The portable size of the printed circuit board makes it easy to install it in tight spaces. The 1336 drives are used to regulate the motor speed and control torque of a motor. The drives are all equipped with an operator interface module which make it easier for the operators to communicate with the drive. The 74101-169-62 gate drive printed circuit board increases the low power input and converts it into high power input so that all the components of the adjustable frequency drive get powered on. The gate drive PCB is essential where there is an IGBT brake system. The 1336 drives are also equipped with an IGBT braking system for cost-effective performance without needing to use external chopper circuits.

The Allen-Bradley 74101-169-62 gate drive printed circuit board is located inside the Allen-Bradley 1336 series drive that it is installed in. It can be accessed through the back panel of the drive if it needs to be repaired or replaced. The adjustable frequency drive comes with equipment that needs to be protected against electrostatic discharge. Special precautions should be taken while installing or repairing the board to avoid electrical damage. The 74101-169-62 gate drive printed circuit board should be placed beneath the main control board and connected to it by using the micro port.