1336F-A007-AA-EN-HASB

The 1336F-A007-AA-EN-HASB drive is an Allen-Bradley 1336 Plus II adjustable frequency drive. With 3-phase 200 to 240 Volts AC input voltage, the drive’s output power rating is 7.5 Horsepower (5.5 kilowatts). With single-phase input voltage, the drive output power rating is only 50% of the 3-phase output power rating. The 1336F-A007-AA-EN-HASB drive is designed for use on power supply systems with symmetrical line voltages. Allen-Bradley recommends the implementation of static-control safety measures to prevent damage to the ESD-sensitive drive components. The technicians working on the drive should be trained and experienced at servicing 1336 Plus II drives. No work should be done on the drive until after it has been switched off and disconnected from power, and after sufficient time has passed to allow the bus capacitors to discharge completely. The DC bus voltage can be measured on the terminals provided for this purpose on the TB1 terminal block. The HMI on the drive is a snap-in cradle with a blank plate that can be replaced with an external HMI.

The frame size of the Allen-Bradley 1336F-A007-AA-EN-HASB 1336 Plus II series adjustable frequency drive is A4. A nameplate for this drive is attached to the bottom portion of the chassis behind the cover. The minimum mounting requirements for proper heat dissipation include 4 inches of horizontal separation and 6 inches of vertical separation between the drive and adjacent devices. Allen-Bradley does not recommend mounting A4 drives like the 1336F-A007-AA-EN-HASB drive on a combustible surface. However if the drive has to be mounted on a combustible surface, then spacers should be provided under the mounting feet for additional heat dissipation. The 1336F-A007-AA-EN-HASB drive is equipped with an MOV for surge protection. The MOV also provides phase to phase and phase to ground protection. Either an input circuit breaker or an input fuse can be used with the 1336F-A007-AA-EN-HASB drive. The protective housing of the drive is IP 20 rated.