The Allen-Bradley/Rockwell Automation 1336F-AQF07-AN-EN is a motor controller with adjustable frequency. The controller has an open enclosure type. The 1336F-AQF07-AN-EN displays programming parameters in the English language and its manual is in English. The controller is interfaced with the input power through a terminal block. The terminal block (TB1) has 5 terminals: the potential earth ground (PE), true earth ground (TE), AC line input terminals (R, S, T), DC bus terminals (-DC, +DC), and the motor connection (U, V, W) terminals. When performing the analog control and signal wiring processes on the 1336F-AQF07-AN-EN or any other drive in the 1336 PLUS II family, use stranded copper wires with a size ranging from 18 to 22 AWG. It should also be twisted wire with minimum insulation that can withstand a voltage of 300 Volts and a temperature of more than 60 degrees Celsius. Note that a spacing of 1 foot should be maintained between the signal cables and the motor cables if the signal cable that is used is unshielded. The spacing should be facilitated by using either a separate conduit, a cable tray, or metal dividers.

The Allen-Bradley/Rockwell Automation 1336F-AQF07-AN-EN motor controller has a digital input frequency accuracy of 0.01% of the set output frequency and an analog input frequency accuracy of +/-0.4% of the maximum output frequency. As with other Allen-Bradley/Rockwell Automation 1336 PLUS II drives, the 1336F-AQF07-AN-EN motor controller allows for 2 acceleration and deceleration times that can be independently programmed from 0 seconds to 3600 seconds in increments of as little as  0.1 seconds. Additionally, the 1336F-AQF07-AN-EN motor controller has a proactive current limit capability that can be programmed from 20 to 160% of the rated output current.