The Allen-Bradley 1336F-B015-AN-EN-GM1-HAS2-L6 drive has an open enclosure and it is a variable speed drive that comes with a voltage that ranges from 380 to 480 Volts AC with a tolerance of +10% and -10% and it reaches a normal duty output rating of 15 Horsepower. This is a 3-phase drive manufactured by Allen-Bradley in the 1336F Plus II series. The Allen-Bradley 1336F-B015-AN-EN-GM1-HAS2-L6 variable speed drive cannot come into contact with liquids or corrosive materials. It needs to be installed in a clean location and it must not be exposed to temperatures higher than 50 degrees Celsius. It is also important to note that this drive is intended for indoor environments only. It must not be exposed to weather conditions such as rain or direct sunlight since these could cause permanent damage to the whole structure of the drive.

The Allen-Bradley 1336F-B015-AN-EN-GM1-HAS2-L6 variable speed drive and all of its components need to be grounded to reduce electrical noise. In order to provide a better resistance to electrical noise, all the cables and wirings can be filtered and shielded, and the signal and power cables must be separated. In order to avoid power losses, it is important to keep the motor cables as short as possible and when the drive is used near residential areas, it needs to be filtered so that it does not modify or interfere with radio frequency signals in the area. The Allen-Bradley 1336F-B015-AN-EN-GM1-HAS2-L6 variable speed drive comes with a digital potentiometer embedded with its programmer and controller modules. It also has a single point I/O compatible with a B frame and a control interface rated at 115 Volts AC.