1336F-B020-AN-EN-HASP-L5

The Allen-Bradley 1336F-B020-AN-EN-HASP-L5 drive is an adjustable frequency drive from the 1336 PLUS II series. It is designed for controlling motors in high-performance commercial and industrial applications. The drive delivers 20 Horsepower of maximum output power under specific ambient conditions. The ambient conditions specified by Allen-Bradley for the drive are an ambient temperature range 0 to 50 degrees Celsius, 5 to 95% non-condensing relative humidity, and 0 to 1000 meters of elevation. The use of the 1336F-B020-AN-EN-HASP-L5 drive outside of these conditions causes the drive output to derate. The drive output also derates if it is used with single-phase AC voltage instead of 3-phase AC voltage. The drive specifications listed in the drive manual are valid for 4 kilohertz of rated carrier frequency. The range of supported carrier frequencies is from 2 to 8 kilohertz. The 1336F-B020-AN-EN-HASP-L5 drive is designed for 380 to 480 Volts AC 3-phase input voltage.

The HMI module installed on the Allen-Bradley 1336F-B020-AN-EN-HASP-L5 1336 PLUS II series adjustable frequency drive is a programmer-only type of HMI. The drive also includes a control interface that is rated for 24 Volts AC/DC. The enclosure of the 1336F-B020-AN-EN-HASP-L5 drive is open and belongs to the IP 00 protection category. Four holes on the enclosure allow for secure mounting. The 1336F-B020-AN-EN-HASP-L5 drive is designed only for vertical mounting. The drive dissipates heat by natural convection, and good ventilation is essential for proper heat dissipation. For this reason, Allen-Bradley recommends providing a minimum of 4 inches of horizontal space and 6 inches of vertical space between this drive and adjacent drives. To minimize installation and wiring errors, only trained personnel should install the drive and any associated equipment.