The Allen-Bradley 1336F-BRF10-AA-EN5 drive is a 3-phase AC drive that falls into the Allen-Bradley 1336 PLUS II category of drives. It drives fans and pumps in industrial automation systems. This type of drive uses an internal fan to lower its internal temperature. It has short-circuit trip protection on the output side as well as over- and undervoltage protection and phase-to-ground protection. The Allen-Bradley 1336F-BRF10-AA-EN5 controls the speed of 1 Horsepower (0.75 kW)-rated motors. Its mechanical protection rating is IP20 (NEMA/UL Type 1 enclosure). The 1336F-BRF10-AA-EN5 should not operate at a temperature higher than 40 degrees Celsius and it should not be stored at a temperature that exceeds 70 degrees Celsius.

The 1336F-BRF10-AA-EN5 has a 3-phase input voltage of 380 to 480 Volts AC, but if needed, it can be supplied with 513 to 620 Volts DC too. Its output voltage can vary between 0 and 480 Volts AC. It transforms very little energy to heat because it is 97.5% efficient. The Allen-Bradley 1336F-BRF10-AA-EN5 can be programmed to work with 2 acceleration and deceleration times, which can each be programmed between 0 and 360 seconds in 0.1-second increments. For up to 1 minute, it has a 150% overload capability, and it can withstand short-circuits of up to 200 kA. This unit has 4 programmable relay control outputs (2 of them are NO, and 2 of them are NO/NC) that can be found on Terminal Board 2, Terminals 10 to 18. On Terminal Board 3, there are 9 digital inputs available, and 6 of them are programmable. The drive is also equipped with terminals to receive analog inputs and to generate analog outputs.