The Allen-Bradley/Rockwell Automation 1336F-BRF75-AA-EN-HAS2-L4E drive is an AC drive with a user adjustable frequency. Before powering up the drive after its installation, the operating environment should be cleared of any mounting tools and of any loose items. The tightening torque levels on all of the terminals should be checked to confirm that they adhere to the recommended or required levels. Additionally, before powering up the 1336F-BRF75-AA-EN-HAS2-L4E AC drive or any other Allen-Bradley AC drive, close the door of its enclosure. To minimize the chances of damage caused by a faulty drive or by a faulty drive connection, the users should stand at a distance when powering up the drive for the first time.

It is recommended that the Allen-Bradley/Rockwell Automation 1336F-BRF75-AA-EN-HAS2-L4E AC drive first be programmed by using the rated motor parameters. These parameters include the nominal voltage and current, nominal frequency, and the nominal power factor parameters. Once these rated parameters have been set, the motor should be checked to ensure that it is rotating in the desired direction (either forward or in reverse). Note that at this point in operation, the controlled motor has still not been interfaced with any load and it is still being operated at a low speed. If the motor shaft is not rotating in the desired direction, the drive should be powered off and the capacitors should be left to discharge before interchanging the motor power connections. For the human-machine interface module (HMI), the 1336F-BRF75-AA-EN-HAS2-L4E accommodates a programmer/controller HMI with a digital pot and uploading and downloading capabilities. On its control terminals, the 1336F-BRF75-AA-EN-HAS2-L4E  drive supports a transistor-transistor logic contact and an encoder feedback module. The input voltage rating for the 1336F-BRF75-AA-EN-HAS2-L4E is 480 Volts AC.