1336-B010-EAD-FA2-L3

The 1336-B010-EAD-FA2-L3 is a variable frequency drive with a factory installed basic control panel for open or NEMA Type 1 enclosures from Rockwell Automation. Apart from the basic control panel, the 1336-B010-EAD-FA2-L3 comes with a 115 Volts AC logic interface board. The interface board connects to the main control board through jumpers J8 and J9, increasing the control wiring configurations for the 1336-B010-EAD-FA2-L3. The drive uses male and female jumpers to complete a circuit between two pins. Also, the drive uses the set option to feed information into the controller. The information is used to set the parameter values. Additionally, the set option on the 1336-B010-EAD-FA2-L3 can be used to change the selector switch settings.

Troubleshooting the 1336-B010-EAD-FA2-L3, like with any other 1336 adjustable frequency AC drive, is only possible when using a Range DVM, DMM, or VOM with a range capacity of at least 1000 Volts, an oscilloscope with at least a 1 MegaHertz frequency response range, and a 1336-MOD-E1 hand-held terminal. The 1336-B010-EAD-FA2-L3 features a standard local display, a programming panel, and an SW1 switch. The switch is used to enable or disable the “Enter” pushbutton and in turn, controls how the drive programming is done. Additionally, the 1336-B010-EAD-FA2-L3 can be interfaced with an optional local control panel which allows for the setting of the start, stop, and jog functions, among others. When the optional panel is not specified when purchasing the 1336-B010-EAD-FA2-L3, its place on the drive will be covered with a blank plate. The standard display panel is also used by the drive to display error codes for easier troubleshooting.