25C-A8P0N114

The 25C-A8P0N114 PowerFlex 527 Variable Frequency Drive by Allen-Bradley is an 8A, 1.5KW, adjustable drive with a built-in EtherNet/IP and safety protocol dual network port, with dynamic braking and a line filter. It is built for any Allen-Bradley Logix Programmable Automation Controller. The drive is designed to have a BUS under-voltage and over-voltage trip of 190V DC and 405V DC, respectively, with a voltage tolerance of -15-10%, at 47-63Hz, and it has a Logic control and power ride thru time of 0.5s and 100ms, respectively. The 25C-A8P0N114 provides a 200% hardware limit, and a 300% instantaneous fault over-current control, and it has Class 10 motor overload protection. The drive has a 0.98 power factor across every speed range, and it utilizes an IGBT (Isolated Gate Bipolar Transistor). The 25C-A8P0N114 provides a short-circuit protection with fault limit of 100,000A, and it offers a phase-to-phase and phase-to-ground, short-circuit and ground fault trip. The drive has a selectable carrier frequency of 2-8 KHz, and it can provide frequency control with the Basic Volts/Hertz, the Sensorless Vector Control, and the Sensorless Vector Control Economizer, which a frequency accuracy of ±0.05% of the configured output frequency. The 25C-A8P0N114 also provides positioning and velocity control via the Closed Loop Position Vector Control, and the Closed Loop Velocity Vector Control with ±0.1% performance speed across a 100:1 speed range. It has an output voltage range between 0 and the rated motor voltage, at a programmable output frequency of 0-590Hz, and it has an output control efficiency of 97.5%. The drive offers multiple stop modes, and it has an intermittent overload protection of 150% overload for about 60s, and 180% for up to 3s. The 25C-A8P0N114 has 2 isolated, 10-bit, ±10V and 4-20mA Analog inputs, with 4 programmable, 6mA, digital inputs with Source and Sink modes, selectable via a DIP switch. It also has optically isolated and reverse voltage protected safety inputs with <10mA input current and a SELV/PELV power supply. The 25C-A8P0N114 has 2 programmable control relay outputs, and a 10-bit, non-isolated, 0-10V or 4-20mA Analog output. It has incremental and dual channel Encoders with 90o, ±27o Quadrature, at 25 oC, and can allow 5V, 12V, and 24V DC at 250mA. The drive has an installation height of 1000m (3300ft) max and is built to resist an operational vibration of 2G with a shock of 15G. The 25C-A8P0N114 has an 81W maximum power loss and is encased in an IP20-rated open enclosure and the compact B frame, and it also has an IEC 60721-3-3 to level 3C2 compliance conformal coating. It has a DIN rail or Screw mounting methods, and a sound pressure level of 53dBA max. It weighs approximately 1.6Kg and has an approximate volume of 87mm x 180mm x 172mm. Since this drive is designed for industrial use and on factory floors, there is No EMC Filtering Option.