20GEANC205JA0NNNNN

The 20GEANC205JA0NNNNN variable frequency drive is an industrial motor control drive. It is manufactured by Allen-Bradley in the PowerFlex 755TS series. The drive has 2 integrated gigabit Ethernet ports. These 2 network ports allow the use of a ring network topology. The major advantage of using a ring topology is redundancy, which means that network communication is not affected by a cable break or node failure. In addition to a ring topology, star and linear topologies can also be used. The 20GEANC205JA0NNNNN drive has a slot-based architecture. The operators can install plug in modules for HMI, communication, feedback, I/O, and safety features. Two HMI modules are available, 9 communication module options are available, 3 feedback module options are available, 7 I/O module options are available, and 4 safety module options are available.  In addition, terminators, brake resistor kits, reflected wave reduction modules, and isolation transformers are also available.

The Allen-Bradley 20GEANC205JA0NNNNN PowerFlex 755TS series motor control drive’s AC input voltage rating can be 400 Volts AC 3-phase and single-phase voltage, but only 3-phase AC input supports the full output rating for the drive. The drive can also operate at 540 Volts DC. The range of supported line frequencies is from 47 to 63 Hertz. The maximum short-circuit rating is 100,000 Amps RMS symmetrical. The actual short-circuit rating is determined by the AIC rating of the installed circuit breaker/fuse. The minimum drive to motor power ratio is recommended to be not less than a 1:2 ratio. The maximum drive to motor power ratio is recommended to be not less than a 2:1 ratio. The rated current output of the 20GEANC205JA0NNNNN drive is 205 Amps and the power output rating is 110 kilowatts. The drive enclosure is open but the drive has a high level of corrosive gas protection. The ingress protection rating of the 20GEANC205JA0NNNNN drive’s enclosure is IP 20 for the front panel and IP 00 for the other drive parts.