The 150-F625JHE is a solid-state controller, manufactured and designed by Allen-Bradley and it belongs to the SNC-Flex series. The Allen-Bradley 150-F625JHE solid-state controller operates with a three-phase input voltage of 200 to 208 Volts AC and a frequency of 50 to 60 Hertz. It has 650 A and 500 Hp with a 460 Volt AC control rating. The control voltage is 110 to 120 Volts AC. The 150-F625JHE solid-state controller features an IP54 (NEMA Type 12) enclosure; this enclosure is intended for industrial purposes. It will protect the controller from external particles that could provoke damages or reduce the performing rate of the controller. The temperature range inside the enclosure should not exceed the -5 to 50 degrees Celsius (23 to 122 degrees Fahrenheit). It is also recommended to leave clearances between the controller and the enclosure. This controller must be mounted in a vertical position.

The 150-F625JHE solid-state controller has a diagnostic mechanism and metering functions that can be accessed through an LCD display and the controller can also be programmed with the built-in keypad and an external LCD display. One of the main functions of the controller, which is pump stopping, could cause motor heating depending on the dynamics of that specific system. As a solution for this inconvenient, users must select the lowest stopping time that will stop the pump in an effective way. The principal modes offered by the Allen-Bradley 150-F625JHE solid-state controller are soft start, current limit, dual ramp start, the three of them with selectable kick start, full voltage start, preset slow speed, soft stop, among others.