592-EC5BC

The 592-EC5BC is an electronic overload relay that belongs to the bulletin 592 series. Specifically, it is under the E3 Plus with voltage monitoring sub-category of overload relays from Allen-Bradley. This electrical device has an adjustable operating current range of 3-15 Amperes and comes with both automatic and manual reset. Aside from providing electronic overload protection, this electrical device is also capable of a variety of monitoring and detection functions such as Overcurrent (Jam) Detection, stall detection, underload detection, and current imbalance. Additionally, it is equipped with warning settings and conforms to ODVA DeviceNet requirements. This overload relay has special application compatibility with Variable Frequency Drives (VFD). The 592-EC5BC nominal operating voltage both complies with the NEAM and IEC standards such as 600 V and 690V / 1000V, respectively. It is a microprocessor type overload relay with an adjustable trip class of 5-30. It has built-in ambient temperature compensation and adjustable delay for phase loss event detection. This electronic overload relay supports operation with 1-Phase or 3-Phase power systems, configurable via the assigned device parameter without the need for wiring modifications. The 592-EC5BC has built-in Six (6) discrete inputs and Two (2) discrete outputs which can be used for external status indications, hardware logic sequencing, and interlocking of other systems. Being an E3 Plus overload relay, this drive is capable of DeviceLogix connectivity, allowing communication with Devices supporting DeviceNet V 3.0 or later. It may also be downloaded with simple logic routines using standard and typical binary operands and instructions including timers, counters, and latches.

and a member of the Bulletin 592 Overload Relays and the E3/E3 Plus product lines. It operates on a full load current rating from 3 to 15 Amps, and it comes with a voltage protection function and an energy monitoring function. The 592-EC5BC Solid-State Overload Relay features 2 outputs and 6 inputs and external ground fault sensor input monitoring. It has a NEMA contactor size of 0 to 2 and it is suitable for use with the Allen-Bradley Bulletin 500 devices. This relay comes with ground fault protection with an external ground fault sensor current rating of 20 milliamps. The E3 and E3 Plus Overload Relays, including the 592-EC5BC Solid-State Overload Relay, provide configurable phase loss protection that allows the technicians to disable or enable functions and set the time delay setting, which can be adjusted from 0.1 to 25 seconds. It has a trip level that is factory-set at the current imbalance measurement of 100 percent. The Allen-Bradley 592 series 592-EC5BC Solid-State Overload Relay features a remote trip function that allows for an external device like a vibration sensor to help induce E3 or E3 Plus Overload Relay to trip. It also comes with an external device relay contact that is wired to the E3 or E3 Plus Overload Relay’s discrete inputs. The discrete inputs can be configured with the option that assigns a remote trip function. The Allen-Bradley 592-EC5BC Solid-State Overload Relay also features diagnostic functions and it and other devices in the E3 and E3 Plus Overload Relay product lines allow the operates to monitor diagnostic information over the DeviceNet network including the device status, the history of the past 5 trips, trip status, time to an overload trip, history of positive warnings, hours of operation, warning status, and the number of stars.