MPL-A1510V-EJ42AA

The MPL-A1510V-EJ42AA servo motor is an MPL low-inertia servo motor that belongs to the MPL series by Allen-Bradley. This motor consists of a brushless servo motor that is specially used for its great advantages such as its high torque capabilities despite having a motor size that has been reduced for the drive to occupy the least amount of space possible in the industrial environment. The Allen-Bradley MPL-A1510V-EJ42AA MPL low-inertia servo motor comes with a rated speed of up to 8000 RPM and an output of 0.16 kilowatts. It employs a voltage of 230 Volts and a frequency of 50 to 60 Hertz. It is important that the servo motor be included in the ground system and that motor cables and drive cables be as short as possible in order to avoid power loss. Servo motors generally generate sufficient heat to cause overheating. To avoid this issue, the MPL-A1510V-EJ42AA servo motor needs to be installed in an open space. Leaving sufficient clearances around the motor enables the motor to release enough heat to operate properly.

If overheating occurs frequently, it is possible that the life of the MPL-A1510V-EJ42AA MP low-inertia servo motor will be compromised. The Allen-Bradley MPL-A1510V-EJ42AA MP low-inertia servo motor has a frame size of 63 millimeters and a magnet stack length of 25.4 millimeters. It is important to note that this motor provides a single-turn absolute encoder as a feedback device. Periodic inspections are highly recommended for the Allen-Bradley MPL-A1510V-EJ42AA MP low-inertia servo motor. The motor cables tend to loosen over time and lubrication might be required. The motor is not able to be immersed in liquids unless a shaft seal or kit is installed. Shaft seals also need to be lubricated if they are installed.