MPL-B230P-EJ72AA

The MPL-B230P-EJ72AA is a brushless, asynchronous AC servo motor from the Kinetix MP series. The entire MP series, including the MPL-B230P-EJ72AA features low-inertia and high Torque output. Additionally, it is part of the smart motor technology which comes with an on-board memory for retaining of motor identity.

The MPL-B230P-EJ72AA has an operating temperature of 0 - 40º C or 32 - 104º F. The physical dimensions of the MPL-B230P-EJ72AA meets the Standard IEC72-1 mounting dimension and provided with IEC metric sized Type FF mounting holes. The entire MP series, including the MPL-B230P-EJ72AA is UL recognized components to applicable UL and CSA standards and CE marked for all applicable directives. Additionally, the MPL-B230P-EJ72AA has higher acceleration due to the inclusion of rare earth magnets in the equipment’s design.

The MPL-B230P-EJ72AA has an output power rating of 0.86 kW, continuous stall Torque of rating of 2.1 N-m with a maximum operating speed of 5000 revolutions per minute (rpm). As a feedback device, this servo motor is pre-installed with a 128 sin/cos, absolute single-turn encoder that utilizes Hiperface protocol.

As optional additions, the MPL-B230P-EJ72AA may be installed with a 24VDC holding brake, keyless shaft and a shaft seal. Aside from protection to contaminants from making direct contact to the internal parts of the servo motor, the shaft seal increases the protection rating of the servo motor. As standard, the motor is provided without a shaft seal with equivalent protection of IP55. When installed with an appropriate shaft seal, the environmental rating meets IP66 requirement.

The MPL-B230P-EJ72AA drive should not be lifted or handled by the motor shaft. Doing so can cause personal injury or damage the drive. The MPL-B230P-EJ72AA drive requires a relative humidity range of 5 to 95%, non-condensing. The drive should be operated in an environment where the temperature range is from 0 degrees Celsius to 40 degrees Celsius. While powered down or in storage, the ambient temperature should be from -30 to 70 degrees Celsius. When it is in storage, the MPL-B230P-EJ72AA drive should be in a non-corrosive environment. The MPL-B230P-EJ72AA drive should be shielded to protect the motor housing. The users should inspect the motor on a regular basis for notable signs of damage. If there is excessive wear, ensure that the drive is replaced. The MPL-B230P-EJ72AA drive comes with the aluminum housing and it has a shock resistance rating of 20 G peak.