MPL-B430P-SK22AA

The MPL-B430P-SK22AA servo motor has an armature voltage rating of 400 Volts AC. The motor uses a single-turn absolute encoder and it follows the Hiperface protocol. Neither a shaft key nor a shaft seal is present in this drive. The motor runs with 5000 rpm of speed with a normal load. The motor has a power-driven mechanism that supplements primary control that is operated with a small amount of force. This motor converts electricity into precisely-controlled mechanisms by using a negative feedback mechanism. The MPL-B430P-SK22AA servo motor is an advanced 3-phase servo motor which can precisely control the position and direction of the client’s device. The motor is capable of operating with maximum radial load or a maximum axial shaft load. The radial load is applied in the middle of the shaft extension. The motor is highly efficient in terms of operation. During the operation of the motor, sufficient clearance, heatsink mass, and airflow for the motor should be provided so that the temperature stays within a range of 0 to 40 degrees Celsius. The environment should be relatively humid with 5 to 95% non-condensing relative humidity. When not in use, the low-inertia motor can be stored at a temperature between -30 and 70 degrees Celsius.

The MPL-B430P-SK22AA servo motor has no brake system installed. Mounting is possible in this servo motor variant via the IEC metric flange. A single-turn high-resolution encoder is present in the servo motor for real-time feedback. It passes the feedback information to the operators of the motor through serial communication. An optional shaft seal can be installed in the servo motor. The shaft seal is rated with an IP 66 protection rating. It is dust tight and it is protected against powerful water jets from all directions. The MPL-B430P-SK22AA servo motor features a new SpeedTEC DIN connector which allows for flexible operation of connectors and the use of a single cable family.