MPL-B4530K-MJ24AA

The Allen-Bradley MPL-B4530K-MJ24AA is a Kinetix servo motor that is part of the MPL series of low inertia output. This servo motor delivers high torque output in reference to its physical size, having a frame size of 130 mm. It exhibits faster acceleration due to the integrated rare earth high-energy magnets installed to this motor. The MPL-B4530K-MJ24AA is equipped with standard configuration without factory options installed. It comes with a 24 VDC holding brake that is used for keeping motor shaft at Zero (0) rpm up to the motor’s rated torque. It also has a multi-tun, high resolution absolute encoder that transfers motion data to the partner servo drive via HiperFace protocol. The MPL-B4530K-MJ24AA features a frames size of 130 mm and magnet stack length of 76.2 mm or 3 inches and operates at maximum speed of 4000 revolutions per minute (rpm). It has a shaft key however, shaft seal is not yet installed. Optional shaft seal to prevent process liquids from entering the motor and increase protection rating from IP50 to IP65 / IP66 may be installed. Recommended shaft seal has catalog number MPL-SSN-A5B5. To operate the MPL-B4530K-MJ24AA and perform the desired motion sequence, this servo motor must be paired to a servo drive. Recommended and compatible servo drives are Kinetix 5500, 5700, 6200/6500, 6000, 300/350, 2000, and 7000 drives. The MPL-B4530K-MJ24AA’s axial radial force rating varies depending on the speed. Specifically, 133 kg (293 lb) @ 500 rpm, 10g kg (232 lb) @ 1000 rpm; 85 kg (185 lb) @ 2000 rpm; 73 kg (161 lb) @ 3000 rpm and 66 kg (146 lb) @ 4000 rpm.

Engineered by Allen-Bradley, the MPL-B4530K-MJ24AA servo motor is a premium magnet rotary low-inertia servo motor classified under the MP series of servo motors. The MPL-B4530K-MJ24AA servo motor features the circular bayonet facing the shaft as its connector. It comes with the 24 Volts DC holding brake with the IEC metric mounting flange and the standard factory designated options. The MPL-B4530K-MJ24AA servo motor features the frame size 130 millimeters and it is a 3-inch magnetic stack length unit. The rated motor power is 4000 revolutions per minute and comes with an ambient storage temperature range of -30 to 70 degrees Celsius. The ambient operating temperature range is 0 to 40 degrees Celsius while the servo motor should be stored in a non-corrosive environment. The MPL-B4530K-MJ24AA servo motor comes with a mounting pilot that is used to ensure proper alignment on the machine. The manufacturer advises the use of stainless-steel fasteners to safeguard the unit. Make sure to comply with all the local industrial safety regulations when installing the servo motor. In addition, the unit should be protected from stray signals that cause EMI. This entails separating the signal cables from the motor cabling and the power wiring. When installing the MPL-B4530K-MJ24AA servo motor, make sure that you do not route the signal cables too close to the motor and the power wires. The power transformers should be isolated or installed with line filters on all of the AC input power lines. This Allen-Bradley servo motor features the DIN connectors that allow for the flexible orientation of the connectors and the use of a single cable family common to all the MP series servo motors.