VPL-B0753F-PJ14AA

The VPL-B0753F-PJ14AA is a Servo motor that is manufactured by Allen-Bradley. This servo motor is designed to operate with Kinetix 5500 and Kinetix 5700 servo motor and compatible for installation in a wide variety of applications such as Packaging, Converting, Material handling, Electronics assembly and Automotive industries. This servo motor mainly features low-inertia output of 0.0000365 kg-m2 (0.00032 lb-in-s2), motor power output of 0.65 kW or 0.87 HP. This servo motor has a rated speed of 4500 revolutions per minute (rpm) and maximum operating speed of 6600 RPM. The VPL-B0753F-PJ14AA has continuous stall torque of 2.16 Nm (19.0 lb-in); peak stall torque of 7.02 Nm (62.0 lb-in) and weighs 2.59 kg (5.70 lb). This servo motor has inherent protection rating of IP50 without shaft seal however, with the installation of an appropriate shaft seal VPL-SSN-F063075 and environmentally sealed cables, the VPL-SSN-F063075 may reach up to IP65 protection rating. Shaft seals are used to prevent process fluids from entering the motor interiors as well as grease from motors from making contact to the process. Shaft seals are recommended to be serviced once every 3 months or depending on the frequency of use or at least once in 12 months. This servo motor is installed with an 18-bit absolute multi-turn digital encoder that supports Hiperface protocol. This functions as the feedback device which is connected to the servo drive for detecting if the target position relative to the motor has been reached. Additionally, this motor is equipped with a 24 VDC holding brake for immediate braking.

The VPL-B0753F-PJ14AA is a permanent magnet rotary servo motor that is designed and manufactured by Rockwell Automation. The motor contains standard factory options and an IEC metric mounting flange with type FF free mounting holes. A right-angled connector is employed on the VPL-B0753F-PJ14AA to connect the motor with power and control signals. The VPL-B0753F-PJ14AA has a shaft key and a digital encoder which uses the Hiperface DSL protocol. The VPL-B0753F-PJ14AA, as with other VP series servo motors, is optimized to the ratings of Kinetix 5500 and Kinetix 5700 servo drives. The motor belongs to the low-inertia family of motors from Allen-Bradley. The operating voltage for the VPL-B0753F-PJ14AA is rated at 480 Volts AC. The Allen-Bradley low inertia motor has a braking circuit with a voltage rating of 24 Volts DC. The axial load rating for the motor is 18.3 kilograms at 2000 revolutions per minute and 11.0 kilograms at 6500 revolutions per minute. When installing the VPL-B0753F-PJ14AA, sufficient cooling should be provided since the motor surface is prone to heating up during operation. To enhance the cooling further, the motor should be installed in an open enclosure with a lot of free flowing air. If this is not a viable option, air should be constantly forced over the VPL-B0753F-PJ14AA when the motor is running. Cables should be routed away from the heat-prone surfaces.