VPL-B1303F-PK12AA

The VPL-B1303F-PK12AA is a low-inertia servo motor that is manufactured by Allen-Bradley. The servo motor comes with a voltage of 400 Volts and it is a 130 millimeters frame size servo motor. The rated speed for the VPL-B1303F-PK12AA is 4,500 revolutions per minute and comes with up to 3 magnet stacks. The module features an 18-bit absolute multi-turn digital encoder with the Hiperface DSL protocol and has a smooth shaft. The VPL-B1303F-PK12AA also is a single-speed TEC DIN connector that has a right angle 325 degrees rotatable connector. The mounting flange for the VPL-B1303F-PK12AA is the IEC metric flange and it features the free mounting holes or the type FF mounting. The VPL-B1303F-PK12AA also comes with the standard factory options. The torque rating for the VPL-B1303F-PK12AA is 8.80 N-m and comes with the IP50 enclosure. The VPL-B1303F-PK12AA is commonly used in the drive series that features the Kinetix 5500 classification.

The VPL-B1303F-PK12AA should be installed in line with the manufacturer’s guidelines. This also includes preventing possible electrical noise, which should be done by following the manufacturer’s guidelines. Basically, the manufacturer’s advice to reduce the effects of EMI is that the installers should isolate the power transformer or install the line filters on all the AC input lines. In addition, it is important that the manufacturers use shielded cables and that the cables be shielded from the power wiring. During installation, make sure that all the equipment is grounded by using a single-point parallel ground system that employs a ground bus bar or the large straps.