1606-XLP90B | Allen Bradley PLC 1606 Switched Mode Power Supplies

1606-XLP90B

1606-XLP90B

Revisions: Ser A 
Description: The Allen-Bradley/Rockwell Automation 1606-XLP90B power supply is a compact power supply. The Bulletin 1606-XLP series 1606-XLP90B compact power supply can support either single operation or parallel operation and the operating mode can be selected with a jumper. It is made to handle single-phase input voltage in ranges of 220 to 375 Volts DC, 100 to 120 Volts AC, and 220 to 240 Volts AC. Additionally, the output voltage range of the 1606-XLP90B compact power supply is from 12 to 15 Volts DC. The steady-state input current ratings for the 1606-XLP90B compact power supply are 1.9 Amps at 120 Volts AC and 0.9 Amps at 230 Volts AC.
Rated 4.6 with 9 reviews

DO Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with DO Supply's 1-year warranty

Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.

Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.


credit cards accepted
better business bureau

Available Now

Submit RFQ for 1606-XLP90B

Add more parts to quote

Description: The Allen-Bradley/Rockwell Automation 1606-XLP90B power supply is a compact power supply. The Bulletin 1606-XLP series 1606-XLP90B compact power supply can support either single operation or parallel operation and the operating mode can be selected with a jumper. It is made to handle single-phase input voltage in ranges of 220 to 375 Volts DC, 100 to 120 Volts AC, and 220 to 240 Volts AC. Additionally, the output voltage range of the 1606-XLP90B compact power supply is from 12 to 15 Volts DC. The steady-state input current ratings for the 1606-XLP90B compact power supply are 1.9 Amps at 120 Volts AC and 0.9 Amps at 230 Volts AC.

DO Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with DO Supply's 1-year warranty

Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.

disclaimer
credit cards
better business bureau
Revisions: Ser A 

Warranty: 1 year DO Supply Warranty Included
Shipping: Worldwide shipping via UPS, DHL, and TNT
Repairs: We offer repair service for the 1606-XLP90B.
Exchange: Exchange credit for your defective unit available.
Conditions: We sell preowned surplus and refurbished parts.

To speak to a sales representative for pricing & lead time:


Rated 4.6 with 9 reviews

    Technical Specifications for 1606-XLP90B

ManufacturerRockwell Automation
BrandAllen-Bradley
Part Number1606-XLP95E
Product TypeSwitched Mode Power Supply
Input Voltage200-240V AC
Output Power95W
Output Current3.9A
TerminalsScrew/Spring Clamp
SignalDC-OK
Output VoltageAdjustable
SizeCompact
Heat GenerationMinimal
ManufacturerRockwell Automation
BrandAllen-Bradley
Part Number1606-XLP95E
Product TypeSwitched Mode Power Supply
Input Voltage200-240V AC
Output Power95W
Output Current3.9A
TerminalsScrew/Spring Clamp
SignalDC-OK
Output VoltageAdjustable
SizeCompact
Heat GenerationMinimal
s

About 1606-XLP90B

The 1606-XLP90B switched-mode power supply is a 1606 series 12 to 15 Volts DC power supply unit manufactured by Allen-Bradley. The 1606-XLP90B power supply uses semiconductor switching techniques and not standard linear techniques to provide a stable output voltage with a low ripple.  After input fuse protection, filtering, and rectification, this power supply unit employs a power switching stage and an output voltage-regulating circuit as it operates. The output voltage is user-adjustable (12 to 15 Volts DC). The input voltage can be AC voltage rated at 100 to 240 Volts AC or DC voltage rated at 220 to 375 Volts DC. The whole power supply unit can be mounted and wired within seconds with no tools required. The 1606-XLP90B power supply is equipped with a jumper for single/parallel operation selection. The device is delivered in a robust IP 20 rated plastic housing that has a ventilation grid.



The 1606-XLP90B power supply is a 90 Watts rated device that is protected against no-load situations, short-circuits, and overloads. It has a green LED operating indicator and it is equipped with quick-connect spring-clamp terminals. The unit is installed onto a DIN rail with a height of 7.5 or 15 millimeters. The power supply can send a digital signal of a fault over a DC normally-open contact that will open when the output voltage goes below 90% of the nominal value. This contact rating is 42 Volts DC at 0.3 Amps or 30 Volts AC at 0.5 Amps. The radiated interference values for this device are below the EN61000-6-3 standard, even when using unscreened output cables that are longer than 2 meters. The 1606-XLP90B power supply complies with all of the major European Union safety standard approvals.



Technical Description of 1606-XLP90B

The Allen-Bradley 1606-XLP90B Switched Mode Power Supply operates with a 200-240V AC Input Voltage and a 95W Output Power. It has Screw/Spring Clamp Terminals and a Compact Size.

Repair Services for 1606-XLP90B

Type Lead Time Price Action
Repair Service 2-4 weeks Askenvelope Get Quote

Our highly skilled technicians can repair your 1606-XLP90B. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.

Revisions for 1606-XLP90B

Please refer to the manual for more information about the 1606-XLP90B such as the wiring diagrams, data sheets and migration or obsolescence details.

Revision Part # Also Known as Availability
1606-XLP90B Ser A
1606-XLP90B/A, Series A, Rev A Request Quote
Common misspellings:
  • l606-XLP90B
  • 16o6-XLP90B
  • 1606-X1P90B
  • 1606-XLP9oB
  • 1606-XLP908
  • 1606XLP90B

Dimensions For 1606-XLP90B

Size
Input Type
Panel Cutout Height in mm
Panel Cutout Width in mm
Terminal Height in mm
Terminal Width in mm
Terminal Overall Depth in mm
Terminal Mounted Depth in mm

Dimensions For 1606-XLP90B

Resolutions For 1606-XLP90B

About

Technical Specifications for 1606-XLP90B

ManufacturerRockwell Automation
BrandAllen-Bradley
Part Number1606-XLP95E
Product TypeSwitched Mode Power Supply
Input Voltage200-240V AC
Output Power95W
Output Current3.9A
TerminalsScrew/Spring Clamp
SignalDC-OK
Output VoltageAdjustable
SizeCompact
Heat GenerationMinimal
ManufacturerRockwell Automation
BrandAllen-Bradley
Part Number1606-XLP95E
Product TypeSwitched Mode Power Supply
Input Voltage200-240V AC
Output Power95W
Output Current3.9A
TerminalsScrew/Spring Clamp
SignalDC-OK
Output VoltageAdjustable
SizeCompact
Heat GenerationMinimal

About 1606-XLP90B

The 1606-XLP90B switched-mode power supply is a 1606 series 12 to 15 Volts DC power supply unit manufactured by Allen-Bradley. The 1606-XLP90B power supply uses semiconductor switching techniques and not standard linear techniques to provide a stable output voltage with a low ripple.  After input fuse protection, filtering, and rectification, this power supply unit employs a power switching stage and an output voltage-regulating circuit as it operates. The output voltage is user-adjustable (12 to 15 Volts DC). The input voltage can be AC voltage rated at 100 to 240 Volts AC or DC voltage rated at 220 to 375 Volts DC. The whole power supply unit can be mounted and wired within seconds with no tools required. The 1606-XLP90B power supply is equipped with a jumper for single/parallel operation selection. The device is delivered in a robust IP 20 rated plastic housing that has a ventilation grid.



The 1606-XLP90B power supply is a 90 Watts rated device that is protected against no-load situations, short-circuits, and overloads. It has a green LED operating indicator and it is equipped with quick-connect spring-clamp terminals. The unit is installed onto a DIN rail with a height of 7.5 or 15 millimeters. The power supply can send a digital signal of a fault over a DC normally-open contact that will open when the output voltage goes below 90% of the nominal value. This contact rating is 42 Volts DC at 0.3 Amps or 30 Volts AC at 0.5 Amps. The radiated interference values for this device are below the EN61000-6-3 standard, even when using unscreened output cables that are longer than 2 meters. The 1606-XLP90B power supply complies with all of the major European Union safety standard approvals.



Technical Description of 1606-XLP90B

The Allen-Bradley 1606-XLP90B Switched Mode Power Supply operates with a 200-240V AC Input Voltage and a 95W Output Power. It has Screw/Spring Clamp Terminals and a Compact Size.

Repairs
Type Lead Time Price Action
Repair Service 2-4 weeks Askenvelope Get Quote

Our highly skilled technicians can repair your 1606-XLP90B. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.

Type Lead Time Price Action
Repair Service 2-4 weeks Askenvelope Get Quote

Our highly skilled technicians can repair your 1606-XLP90B. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.

Revisions

Please refer to the manual for more information about the 1606-XLP90B such as the wiring diagrams, data sheets and migration or obsolescence details.

Revision Part # Also Known as Availability
1606-XLP90B Ser A
1606-XLP90B/A, Series A, Rev A Request Quote

Common misspellings:
  • l606-XLP90B
  • 16o6-XLP90B
  • 1606-X1P90B
  • 1606-XLP9oB
  • 1606-XLP908
  • 1606XLP90B
PDF