The specifications on the Allen-Bradley 1732E-12X4M12QCDR Digital I/O Dual-Port Ethernet Module include 12 inputs and 4 outputs along with an enclosure type that meets the IP 65, 66, 67, 69K, and Type 4X standards for indoor use only. The input specifications for the Allen-Bradley Ethernet Module include a maximum off-state input voltage of 5 Volts with a maximum on-state input voltage of 30 Volts. The nominal on-state input voltage is 24 Volts, and the module's minimum on-state input voltage is 12 Volts. Its maximum off-state input current rating is 1.5 milliAmps at 5 Volts, and the module's maximum on-state input current is rated at 5 milliAmps at 30 Volts. The input delay time on the 1732E-12X4M12QCDR Ethernet Module can be set to intervals of 0, 1, 2, 4, 8, and 16 milliseconds. The maximum on-state output voltage drop rating on the Ethernet module is rated at 0.5 Volts, and its minimum off-peak blocking voltage is 30 Volts.

The general specifications on the 1732E-12X4M12QCDR Allen-Bradley Ethernet Module include minimum and maximum auxiliary power voltage ratings of 12 and 30 Volts, respectively. The maximum Ethernet system power current is 1 Amp, with its maximum rating per output module being 2 Amps. The maximum sensor source current per input reads at 50 milliAmps, with its maximum per connector being 100 milliAmps. The isolation voltage on the 1732E-12X4M12QCDR Ethernet Module is 50 Volts (continuous) with a basic insulation type. The operating temperature should range between -4 and 140 degrees Fahrenheit and the storage temperature should fall between -40 and 185 degrees Fahrenheit. The relative humidity should not go below or above 5 or 95% (non-condensing). The Ethernet Module has an approximate weight of 0.43 kilograms (0.95 pounds). The module dimensions are 200 x 60.4 x 45 millimeters (7.87 x 2.38 x 1.77 inches).