The Allen-Bradley 1769-IT6 Thermocouple/mV Input Module is a compact device that measures thermocouple and millivolt signals. These measurements are digitally converted and stored as analog data in any combination of up to six thermocouple or millivolt analog sensors. Over-range, under-range, open-circuit detection, and indication are provided. Each input channel can be configured via system-compatible software for specific filter frequency, input device, and data format.
The 1769-IT6 Compact Input Module has 6 input channels plus 2 CJC sensors. It has a Delta Sigma converter type and its response speed per channel is input filter and configuration dependent. It communicates with the controller via the bus interface where it also receives power from the 5-24V DC system power supply. The 1769-IT6 module draws a maximum current of 100 mA at 5 Volts DC, and 40 mA at 24 Volts DC. Upon powerup and when a channel is enabled, this input module performs auto-calibration. Auto-calibration can also be programmed to run every five minutes.
The 1769-IT6 is UL 508 listed, C-UL certified (under CSA C22.2 No. 142), and CE compliant for applicable directives. It can be attached to an adjacent I/O module or to the controller before or after (single module replacement) mounting. To reduce electrical noise, install this measurement device at least two slots away from an AC power supply. When mounting, maintain a minimum spacing clearance of two inches on all sides for adequate ventilation.
FAQ for 1769-IT6
Question: What is the power supply distance rating for the 1769-IT6 module?
Answer: The power supply distance rating for the 1769-IT6 is 8 modules.
Question: Does 1769-IT6 require manual calibration?
Answer: No, 1769-IT6 automatically calibrates after every powerup and every time a channel is enabled. Autocalibration every five minutes is also available.
Question: Can this module be purchased with a warranty?
Answer: Yes, the 1769-IT6 comes with a free one-year warranty from DO Supply, Inc.
Question: What type of software does the 1769-IT6 use?
Answer: The 1769-IT6 uses RSLogix5000 software.
Question: What type of cable does this module require?
Answer: The 1769-IT6 uses a 6-point communication cable.
Question: Where can I send the 1769-IT6 to be repaired?
Answer: DO Supply, Inc. offers a variety of repair services for the 1769-IT6.
Repair Services for 1769-IT6
||$369||Add to Cart |
Our highly skilled technicians can repair your 1769-IT6. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.
Revisions for 1769-IT6
Please refer to the manual for more information about the 1769-IT6 such as the wiring diagrams, data sheets,
firmware information and migration or obsolescence details.
|Revision Part #
||Also Known as
||1769-IT6/A, Series A, Rev A