The Allen-Bradley 5094-AENRTBS-QTY5 terminal block is a removable terminal block or RTB for the FLEX 5000 series Ethernet/IP adapter. The adapter is a spring-type adapter that uses stranded copper wire, and this spring RTB is installed on the adapter. The Ethernet adapter uses a DIN rail for mounting. The Flex 5000 series Ethernet adapter transfers data and instructions at a high speed and is used in industrial automation applications. The RTB uses a 22-14 AWG wire for connections. These highly insulated wires offer better performance for heavy-duty use. The 5094-AENRTBS-QTY5 RTB is installed on the front of the network adapter on the bottom side. The adapter has an open enclosure. The RTB is used to supply power to the adapter which then supplies the bus power of the adapter. The temperature of the adapter should not exceed 70 degrees Celsius to avoid overheating.

The 5094-AENRTBS-QTY5 Removable Terminal Block is certified with the CE and other environmental standards. The network adapter uses the rotary switches present on the front side to switch between IP addresses. During the installation of the block, the power supply should be fully disconnected from the adapter. The 5094-AENRTBS-QTY5 RTB simple latches into place inside the adapter and it is easy to remove. The adapter has 300 Volts of isolation and it has basic insulation. The RTB is connected to an external power source and it provides power to the system. The inrush current on the RTB is 5 Amps. The 5094-AENRTBS-QTY5 RTB uses a high quality spring and it has a small form factor. The block should not be exposed to airborne contaminants and sources of extreme heat.