The Allen-Bradley 5094-RTB3WS terminal block is a FLEX 5000 series removable terminal block. The 5094-RTB3WS terminal block comes in an open enclosure. The ATEX temperature code for the block is code T4. The dimensions of the removable terminal block are 53 x 94 x 76 millimeters and it weighs approximately 202 grams. The rated isolation voltage is 250 Volts AC continuous. The recommended wire type for terminations on the 5094-RTB3WS removable terminal block is copper wire. The recommended wire size is 22 to 14 AWG solid or stranded copper wire rated at 105 degrees Celsius. The maximum output ratings are 2 Amps of current at 240 Volts AC and 2 Amps of current at 125 Volts DC. The peak sensor actuator power rating is 10 Amps for 18 to 32 Volts DC.

The 5094-RTB3WS removable terminal block comes with keyswitches that need to be set to correspond to the settings of the installed module. The 5094-RTB3WS removable terminal block forms part of a complete terminal base assembly which also includes either a 50940MBXT or a 5094-MB mounting base. The working temperature range for the block is from -40 to 70 degrees Celsius. Care must be taken to ensure that the block is not used outside this temperature range. The use of cleaning agents for cleaning the 5094-RTB3WS removable terminal block is not recommended. Only an anti-static cloth which is not wet should be used for cleaning the device if required. Only a single conductor should be connected to any terminal on the 5094-RTB3WS removable terminal block. The installation of the 5094-RTB3WS removable terminal block should only be performed by trained technicians. Local and federal regulations should be followed during the installation and operation of the module.