The 5094-RTB3WSXT terminal block from Allen-Bradley is a removal terminal block or RTB. The 5094-RTB3WSXT terminal block belongs to the FLEX 5000 family of Allen-Bradley I/O modules. A removal terminal block like this one is one of the components of a complete terminal base (TB) and the other component is a mounting base (MB). The mounting bases compatible with the 5094-RTB3WSXT terminal block include the 5094-MB mounting base or the 5094-MBXT mounting base. The MBs and the RTBs must be purchased separately and then assembled together. The dimensions of the 5094-RTB3WSXT terminal block are 2.08 x 3.7 x 3.00 inches. It weighs approximately 0.45 pounds. The North American temperature code for the module is T4. The enclosure of the module is open. The wire category that is used is determined by the installed module. Stranded or solid copper wire which is rated for 221 degrees Fahrenheit or greater and which has a 0.34 to 2.5 square millimeter cross-sectional area is suitable for use with the 5094-RTB3WSXT terminal block.

The maximum insulation on the wire on the Allen-Bradley 5094-RTB3WSXT terminal block should be 1.2 millimeters thick. The electrical specifications for the module include 10 Amps of maximum sensor actuator (SA) current power at a voltage range between 18 and 32 Volts DC and 2 Amps of maximum output current rating for 125 Volts DC pr 240 Volts AC. The 10 Amps of the SA power pass-through current draw must not be exceeded under any circumstances. The 5094-RTB3WSXT terminal block is certified for safe use only when the temperature of the air surrounding the module is between -40 and 70 degrees Celsius. The installation, commissioning, operation, and maintenance of the 5094-RTB3WSXT terminal block should be performed by trained technicians who know and follow all of the relevant local and federal electrical regulations.