DO Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with DO Supply's 1-year warranty
Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
The 1784-U2CN cable is a ControlNet cable by Allen-Bradley/Rockwell Automation. It is marked with the cULus, RCM, CE, and CI standards.
DO Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with DO Supply's 1-year warranty
Rockwell Disclaimer: The product is used surplus. DO Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because DO Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, DO Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. DO Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. DO Supply also makes no representations as to your right to install any such firmware on the product. DO Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
Warranty: | 1 year DO Supply Warranty Included |
Shipping: | Worldwide shipping via UPS, DHL, and TNT |
Repairs: | We offer repair service for the 1784-U2CN. |
Exchange: | Exchange credit for your defective unit available. |
Conditions: | We sell preowned surplus and refurbished parts. |
Brand | Allen-Bradley / Rockwell Automation |
Series | PLC 5 |
Part Number | 1784-U2CN |
Description | ControlNet cable |
Voltage | 5.25 Volts DC |
Current | 225 mA |
Standard | CE, RCM, KCC, CI |
Temperature | 0-55 degrees Celsius |
Enclosure | IP 30 |
Isolation voltage | 30 Volts |
ControlNet current | 70 mA at 24 Volts |
UPC | 10612598524836 |
UNSPSC | 43201404 |
Brand | Allen-Bradley / Rockwell Automation |
Series | PLC 5 |
Part Number | 1784-U2CN |
Description | ControlNet cable |
Voltage | 5.25 Volts DC |
Current | 225 mA |
Standard | CE, RCM, KCC, CI |
Temperature | 0-55 degrees Celsius |
Enclosure | IP 30 |
Isolation voltage | 30 Volts |
ControlNet current | 70 mA at 24 Volts |
UPC | 10612598524836 |
UNSPSC | 43201404 |
The 1784-U2CN cable is a USB to ControlNet cable manufactured by Allen-Bradley/Rockwell Automation. By using this cable, an operator can connect a computer (laptop or desktop computer) to a ControlNet network through a USB port. ControlNet is an industrial networking protocol that is used for controlling industrial automation units. The connector cable meets the IP 30 protection rating. It is not water resistant. It runs with a 5.25 Volts DC voltage supply and it has a current rating of 225 milliamps. The isolation voltage of the connector is set at 30 Volts continuous. It is a basic insulation. The ControlNet current value is 70 milliamps at 24 Volts. The 1784-U2CN cable should not exceed 55 degrees Celsius for normal operation. It can be used at up to an altitude of 2000 meters without getting derated. The device has been rated with the cULus, CE, RCM, KCC, and CI standards.
The 1784-U2CN cable is comprised of 3 components. It has connector components on both ends and a node address switch in the center. The switch is used to change the node address. A LED indicator is present on the switch with indicators for the USB status, the module status, and the ControlNet network status. The USB indicator turns on green when the cable is configured but no traffic is present. It starts blinking when there is an active network on the cable. The other indicators work similarly for module status and ControlNet network updates. The 1784-U2CN cable is sensitive to electrostatic discharge which can cause internal damage to the components.
Type | Lead Time | Price | Action |
---|---|---|---|
Repair Service | 2-4 weeks | Ask | ![]() |
Our highly skilled technicians can repair your 1784-U2CN. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.
Size | |
Input Type | |
Panel Cutout Height | in mm |
Panel Cutout Width | in mm |
Terminal Height | in mm |
Terminal Width | in mm |
Terminal Overall Depth | in mm |
Terminal Mounted Depth | in mm |
Brand | Allen-Bradley / Rockwell Automation |
Series | PLC 5 |
Part Number | 1784-U2CN |
Description | ControlNet cable |
Voltage | 5.25 Volts DC |
Current | 225 mA |
Standard | CE, RCM, KCC, CI |
Temperature | 0-55 degrees Celsius |
Enclosure | IP 30 |
Isolation voltage | 30 Volts |
ControlNet current | 70 mA at 24 Volts |
UPC | 10612598524836 |
UNSPSC | 43201404 |
Brand | Allen-Bradley / Rockwell Automation |
Series | PLC 5 |
Part Number | 1784-U2CN |
Description | ControlNet cable |
Voltage | 5.25 Volts DC |
Current | 225 mA |
Standard | CE, RCM, KCC, CI |
Temperature | 0-55 degrees Celsius |
Enclosure | IP 30 |
Isolation voltage | 30 Volts |
ControlNet current | 70 mA at 24 Volts |
UPC | 10612598524836 |
UNSPSC | 43201404 |
The 1784-U2CN cable is a USB to ControlNet cable manufactured by Allen-Bradley/Rockwell Automation. By using this cable, an operator can connect a computer (laptop or desktop computer) to a ControlNet network through a USB port. ControlNet is an industrial networking protocol that is used for controlling industrial automation units. The connector cable meets the IP 30 protection rating. It is not water resistant. It runs with a 5.25 Volts DC voltage supply and it has a current rating of 225 milliamps. The isolation voltage of the connector is set at 30 Volts continuous. It is a basic insulation. The ControlNet current value is 70 milliamps at 24 Volts. The 1784-U2CN cable should not exceed 55 degrees Celsius for normal operation. It can be used at up to an altitude of 2000 meters without getting derated. The device has been rated with the cULus, CE, RCM, KCC, and CI standards.
The 1784-U2CN cable is comprised of 3 components. It has connector components on both ends and a node address switch in the center. The switch is used to change the node address. A LED indicator is present on the switch with indicators for the USB status, the module status, and the ControlNet network status. The USB indicator turns on green when the cable is configured but no traffic is present. It starts blinking when there is an active network on the cable. The other indicators work similarly for module status and ControlNet network updates. The 1784-U2CN cable is sensitive to electrostatic discharge which can cause internal damage to the components.
Type | Lead Time | Price | Action |
---|---|---|---|
Repair Service | 2-4 weeks | Ask | ![]() |
Our highly skilled technicians can repair your 1784-U2CN. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.
Type | Lead Time | Price | Action |
---|---|---|---|
Repair Service | 2-4 weeks | Ask | ![]() |
Our highly skilled technicians can repair your 1784-U2CN. All of our repairs come with a 1 Year DO Supply Warranty. Please contact us for additional information about our repair process.