The 2711P-RBT15 replacement bezel is an operator interface terminal bezel manufactured by Allen-Bradley. It is 15 inches wide and it is made out of white plastic. The compatible PanelView Plus terminal model that this bezel replacement part is made for is the Allen-Bradley PanelView Plus 1500 terminal model. The 2711P-RBT15 replacement bezel is made out of plastic and it is designed to be durable enough to provide a long operating field life as well as the required level of protection for the terminal that it protects. The bezel can be easily removed from a touchscreen by removing the screws which are located back of the display and by removing the sealing gasket. The sealing gasket must be replaced when replacing the bezel. Note that a properly installed terminal leaves a gap between the enclosure and bezel.

The 2711P-RBT15 replacement bezel’s plastic structure dissipates heat efficiently. The bezel and the panel gasket seal have both been tested for chemical resistance. The gasket material is compliant with industry standards. The users are advised to disconnect the power from the terminal when replacing the bezel. It is not necessary to remove the communication module or logic module before replacing the bezel. It provides IP 65, and NEMA 4x, 12, and 13 levels of protection for the terminals that it hosts, and it also acts as a protective enclosure. It is necessary to choose a flat and stable surface to set the display on before removing the bezel unit. The 2711P-RBT15 replacement bezel has good mechanical properties for better performance. The PanelView Plus 1500 terminals and this bezel are recommended for use in indoor locations that are not hazardous.