S801R13N3S

The Eaton Cutler-Hammer S801R13N3S open non-combination soft starter is a reduced voltage soft starter designed to control the acceleration and deceleration of 3-phase industrial motors in critical applications. The S801R13N3S soft starter belongs to the S801 soft starter family that is designed to meet the demands of high-performance industrial applications, and they come with easy-to-use control interface modules for reduced commissioning time. The S801R13N3S soft starter has a current rating of 135 Amps, and it is designed for applications with 200 to 600 Volts AC ratings. It has a rated insulation voltage of 660 Volts AC, and a rated impulse withstand voltage of 6000 Volts AC. The S801R13N3S soft starter is designed to provide protection from overloads resulting from over-current, over-voltage, and overheating. It offers 3 standard start modes and 1 stop mode to accommodate a wide range of applications.

The S801R13N3S soft starter has an integral run-bypass contactor that offers smooth motor operation at a nominal speed, and this bypass also helps to reduce heat dissipation during operation. The S801R13N3S soft starter has 3-pole wiring with box lug connectors on both of the load side terminals, and it is installed by using a mounting plate with tear drop holes.  This soft starter comes with an easy-to-use control interface that allows for easy configuration, even by beginners. The S801R13N3S soft starter has a DC power control that enhances user and equipment safety and provides an additional source of control. It has a designated operating range of -30 to 50 degrees Celsius, and it must be used at less than 95% non-condensing relative humidity. The S801R13N3S soft starter weighs approximately 4.8 kilograms, and it has total mounting dimensions of 111 x 201.1 x 178.6 millimeters.