IC755ACC07GAS

The IC755ACC07GAS gasket is a replacement gasket for the Quickpanel+ series devices. This accessory has been included in the Quickpanel+ series of operator interfaces by GE Fanuc in the intelligent platforms division. This specific accessory is meant to replace the original gasket of an operator interface module. The original gasket comes pre-installed in the module and due to constant wear, it might need to be replaced. The GE Fanuc IC755ACC07GAS replacement gasket for the Quickpanel+ devices comes with 4 mounting holes on the top and bottom of the unit that are useful for securing the module to a surface. To avoid the degradation of the gasket, the insertions or removals of the unit need to be limited and the mounting clips need to be retightened occasionally.

When installing the GE Fanuc IC755ACC07GAS replacement gasket for a Quickpanel+ device, it is important to know that the device needs to be inserted without any cable connected to it or it will not fit the gasket. The power supply also needs to be removed first. Once the device's power has been disconnected, the users need to verify that the GE Fanuc IC755ACC07GAS replacement gasket for the Quickpanel+ device is in the bezel channels located on the sides of the device. Then the gasket needs to be secured, and to be secured properly, it requires a torque range of 0.3 N-m. All the units in the Quickpanel+ series can operate in a temperature range of 0 to 50 degrees Celsius and at a maximum relative humidity level of 85 percent without condensation.