The IC755ACC10GAS gasket is a replacement gasket for the 10-inch Quickpanel+ terminals manufactured by GE Fanuc. This gasket is meant to cover the module of the Quickpanel+ operator interface terminals and at the same time, it works as the structure that covers the screen and each port of the interface. The original gasket comes preinstalled in the operator interface terminal. Certain conditions and environments can cause the degradation of this gasket and that is the main reason why replacement gaskets have been included in the same series. The GE Fanuc IC755ACC10GAS replacement gasket for the 10-inch Quickpanel+ terminals needs to be properly seated in the bezel channel located on the sides of the unit. Space needs to be cut out from the gasket according to the dimensions of the terminal that it protects. The panel thickness goes from 1.6 to 5 millimeters.

The GE Fanuc IC755ACC10GAS replacement gasket for the 10-inch Quickpanel+ terminals need to be secured by using screws that are tightened in a clockwise direction. To avoid degradation and wear on the GE Fanuc IC755ACC10GAS replacement gasket for the 10-inch Quickpanel+ terminals, it is recommended to avoid frequent insertions and removals of the panel and to perform periodic inspections to the mounting screws because these will need to be tightened up occasionally. The terminal needs to be inserted in the gasket without any connections, cables, or anything else attached to it that would prevent it from fitting into the gasket properly. It is also recommended to maintain the temperature and humidity levels around the gasket within the accepted range so that heat and water damages do not affect the gasket.