IC694MDL740

The IC694MDL740 is a discrete output module from the PACSystem RX3i Programmable Automation Controller (PAC) series. Formerly produced by GE Intelligent Platforms (GE IP), this module is now under Emerson Automation. It belongs to the modern designed controller modules, built with Sixteen (16) Positive output channels generating rated voltages of 12 /24 VDC with an output current of 0.5 Amperes per point and 2 Amperes per module. This module has Two (2) groups of Eight (8) outputs each with each group having isolated commons. The IC694MDL740 is a single slot module that mounts to an available slot of the RX3i backplane. It is primarily compatible with motor starters, solenoids, and panel indicators. It comes with individual channel LED indicators that depict the energization state of each channel with a singular Fuse Blown status LED indicator. The IC694MDL740 had the field to backplane isolation rated 250 VAC, continuous; optical isolation which is Frame to ground isolation rated 1500 VAC for 1 minute and group to group isolation rated 250 VAC continuous and 1500 VAC for 1 minute. This module has an inrush current rating of 4.78 Amperes for 10 ms, a maximum output voltage drop of 1 volt, maximum off-state leakage current rated at 1 mA, and 2 ms On and Off response time. This module has a backplane current draw of 110 mA. The number of IC694MDL740 module instances depends on the I/O capacity, the number of available slots, and memory of the host processor. It can be part of a local I/O assembly or part of a larger distributed I/O architecture.

The IC694MDL740 output module is an output module that belongs to the Rx3i PACSystems series by GE Fanuc Automation. This module is specifically a positive logic output module that comes with 16 different output points that are sorted into 2 groups of 8 output points each. This module also provides isolation between these output points so there is no interference between them when operating. The logic characteristic of the module is positive, which means that it can source current to the load from the positive power bus. The GE Fanuc Automation IC694MDL740 Rx3i PACSystems output module is compatible with multiple field devices. These devices can be motors and solenoids, among others. All of the parts need to be powered from an external power supply. The GE Fanuc Automation IC694MDL740 Rx3i PACSystems output module comes with 1 LED Indicator per point which helps the operators have a quick grasp of the current operating statuses of all the devices. It is important to note that this module comes with 16 outputs and that it is a low-voltage device as the blue band on the front label of the module indicates. The GE Fanuc Automation IC694MDL740 Rx3i PacSystems output module has a rated voltage of 12 to 24 Volts DC and an isolation range of 250 Volts AC continuous and of 1500 Volts AC per minute. This module has an overall power consumption rating of 110 milliamps, including all its outputs with 5 Volts DC bus voltage on the backplane. The module can be mounted in any one of the racks from the RX3i system series regardless of the slot.