MR-J60A-UL

The MR-J60A-UL servo amplifier was designed by Mitsubishi as a general-purpose servo amplifier in the MELSERVO-J series. It was designed to control a variety of Mitsubishi servo motors in industrial applications. The MR-J60A-UL servo amplifier can receive signals and amplify them before passing them on to the connected servo motor. It amplifies weak signals to make them strong enough for the connected servo motor to use. The MR-J60A-UL servo amplifier can control the connected servo motor’s operating speed, operating torque, and position. This servo amplifier uses AC voltage when it operates. The input voltage rating of the MR-J60A-UL servo amplifier is 200 Volts AC to 230 Volts AC at a frequency rating of 50/60 Hertz, and its input current rating is 3.2 Amps. The output voltage rating of the MR-J60A-UL servo amplifier is 170 Volts AC at a frequency rating of 0 Hertz to 360 Hertz, and its output current rating is 3.6 Amps. The power supply that the MR-J60A-UL servo amplifier uses is a 3-phase 200 Volts AC power supply. This servo amplifier is CSA-certified and it has been UL-listed. The MR-J60A-UL servo amplifier can operate at ambient temperatures between 0 degrees Celsius and 55 degrees Celsius in environments that do not experience freezing conditions. It can also tolerate up to 90% relative humidity in its environment if there is no condensation. The MR-J60A-UL servo amplifier can also tolerate up to 0.6 G of vibration. The ambient temperature around the servo amplifier should be kept low to extend the servo amplifier’s operating life, but it should be kept above freezing to avoid ice. The MR-J60A-UL servo amplifier should be installed so that it can be seen clearly from the front.