160-AA03PPS1

The 160-AA03PPS1 is a Variable Speed Drive from the 160 SSC series manufactured by Allen-Bradley. This device is connected to a 200 to 240 Volt AC three-phase voltage. It has a 3.0A current rating and a 0,55kW (0.75HP) power rating. It comes with externally attached heatsink design, which reduces the drive’s total power dissipation significantly, compared to the “open style” design. This is a model with the preset speed. The preset speed model is controlled via three digital inputs, which can digitally code eight different preset speeds along with two speed-dependent acceleration and deceleration ramp times. The 160-AA03PPS1 a number of features including hinged finger guards for input and output connectors, ready/fault indicating panel with status LEDs, DC bus test points, a cooling fan, and a DIN latch. With the ready/fault indicating panel only ready and fault signal information is available and all control functions are executed via a control terminal block. Users can not change factory default settings over this panel. When a fault is LED indicated on the panel, correct the cause of the fault, disconnect the power, wait at least one minute, and then re-apply the power.

The 160-AA03PPS1 module’s outer dimensions are 152 x 80 x 165 millimeters (6.00 x 3.15 x 6.51). The product’s shipping weight is 0.94 kilograms (2.07 pounds) and its ambient operating temperature is between 0 and 50 degrees Celsius. Use 75Ö¯ degrees Celsius wire 0.75-4mm2 (12 – 18 AWG) for wiring, and mount the drive with screws or onto a DIN rail (35 millimeters). For protection against excessive current use a fuse, circuit breaker, or manual motor starter. This module’s protective features include overcurrent, excessive temperature (if the heat sink temperature exceeds 95 degrees Celsius), over/under voltage, ground short, and output short-circuit.