150-F201NBR

The Allen-Bradley 150-F201NBR is a Smart Motor Controller from the SMC Flex product category. This soft starter has line Voltage requirement of 200-460VAC, 3-Phase, 50 / 60 Hz while the device control voltage requirement is 24V AC/DC (5-480 A units). This controller has a continuous output current of 201 Amperes and output power of 150 HP at 460VAC rated voltage.

The 150-F201NBR come with an with an open type enclosure. For installation, this controller requires minimum enclosure size of (HxWxD) of 965 mm (38 in) x 762 mm (30 in) x 356 mm (14 in). It supports direct mounting to the enclosure sub-panel via the provided mounting holes located on top and below the controller.

The 150-F201NBR is capable of a wide variety of start and stopping modes specifically Soft Start, Full Voltage Start, Smart Motor Braking, Current Limit Start, Dual Ramp Start, Accu-Stop, Selectable Kickstart, Pump Start, Slow Speed with Braking, Coast-to-rest, Preset Slow Speed, Linear Speed Acceleration (Tachometer required), Soft Stop and Pump Stop. These configurable start and stopping modes allow the motor to perform the required protective start-up and shutdown sequence as well as limit generation of inrush current.

For configuration, this controller has a built-in Human Interface Module (HIM) which is used to configure and operate the drive locally and use as aid in monitoring the status of the drive.

The controller’s power circuit offers 500V AC IEC-rated insulation voltage, with 6000V rated impulse voltage, and a Dielectric withstand of 2,200V, and it has DV/DT protection from its RC Snubber Network. The 150-F201NBR, unlike some controllers in the series, does not come with protection modules, but it provides branch circuit protection using a 600A-rated Class J fuse with a maximum short-circuit rating of 18KA, and it utilizes the i2 t Algorithm for electronic motor overload protection. The 150-F201NBR has a 24V AC/DC control circuit, with a 1600V dielectric withstand and with a 19.2V DC/20.4V AC ON-state input voltage at 7.6mA, and it provides high-temperature control using a 40VA back side installed heatsink fan. It has 4 programmable relays (electromagnetic) output with 3A and 1.5A (NC/NO) contact ratings at 120V AC and 240V AC, which can be configured for normal/up-to-speed/fault/alarm/network control, and it has an alarm contact pre-configured for under load, under voltage overload, overvoltage, voltage unbalance, motor jam, and motor stall. The controller communicates via a DPI port, which provides connection points for optional communication modules, the 150-F201NBR is wired only to standard squirrel-cage induction motors. It has a working temperature range of 23-122°F, with a storage temperature range of -4-167°F at 5 to 95% non-condensing humidity, and it is designed to operate at an altitude of 2000m, without any de-rating. The 150-F201NBR has a net shipping weight of 30.4kg, with a total shipping volume of 560mm x 225mm x 258.3mm, and it has CCC, c-UL-us, UL, and CE certifications.