MPM-B2154B-MJ72AA

The MPM-B2154B-MJ72AA is a medium-inertia servomotor that belongs to the premium permanent magnet rotary servo motor series, specifically the medium inertia series type. This part has been designed and manufactured by Allen-Bradley. The Allen-Bradley MPM-B2154B-MJ72AA medium-inertia servo motor features a multi-turn high-resolution encoder that combines the features of a low-inertia motor with a rotor and these are recommended for applications that require high-inertia loads. The Allen-Bradley MPM-B2154B-MJ72AA medium-inertia servo motor operates with a voltage of 400 Volts and a speed of 1300 RPM. It has four magnet stacks and a bolt circle diameter of 215 millimeters. It is important to note that the connectors of this servo motor are rotatable up to 180 degrees to the right side. The Allen-Bradley MPM-B2154B-MJ72AA medium-inertia servo motor has an IP65 housing that protects it mainly from external particles and liquids dropping. It is fully intended for indoor use and it is dust and water tight. Combined with shaft seals, it can offer a higher degree of protection than average and it is a great option to extend the life of the servo motor.

When combined with a shaft seal, this one can be mounted in different directions and the level of protection will vary depending on this position. For example, if the shaft is down, the servo motor will be protected from dust and spraying water. If the shaft is in a horizontal position, the servo motor will be dust and vertically falling water drops protected. If the shaft is up, the servo motor will be dust-protected, but it will not be protected from water. There are some conditions that must be complied with in order to preserve the optimum functioning of the Allen-Bradley MPM-B2154B-MJ72AA medium-inertia servo motor, these are an operating temperature range that goes from 0 to 40 degrees Celsius and a non-condensing relative humidity of 5 to 95 percent. It is important to keep the servo motor in a non-corrosive atmosphere. It is utterly important to protect the servo motor from electromagnetic interference. The servo motor must be included in a grounding system, cables should be shielded and signal cables must be wired apart from the power cables.