N-3412-2-H00AA

The Allen-Bradley N-3412-2-H00AA is an N-Series Brushless servo motor. This servo motor has a continuous Torque capability of 12 lb-in with a motor winding that is designed for 230VAC external supply voltage. It has a built-in 2000 Line count encoder that requires a supply voltage of 5VDC and supply current requirement of 300 mA. Additionally, this encoder is compatible for use with 26LS31 line driver.

The motor’s encoder has line driver output of Logic 1 =2.5 VDC min @ 20 mA DC source, Logic 0 = 0.5 VDC max @ 20 mA DC sink for A, B, I signals. For HALL signals, Logic 1 is 3.5 VDC min @ 1mA DC source while Logic 0 is 0.5 VDC max @ 5mA DC sink.

The N-3412-2-H00AA servo motor has a maximum operating speed of 6000 Revolution per minute (RPM). The winding is constructed with Four (4) magnetic poles with Phase-to-Phase winding resistance at 25 Deg. Celsius of 2.68 Ohms and Phase-to-Phase winding inductance of 8.6 mH. The same winding has a Thermal resistance of 1.2 oC/Watt and Dieelectric strength of 1800 VACrms 50/60 Hz for 1 minute. Measured from each poer leads to ground wire.

The N-3412-2-H00AA has a rotor moment of inertia of 0.00015 kg-m2; Damping of 0.19 Nm/krpm and Friction Torque of 0.34 Nm; The shaft of this motor is made of 416 Stainless Steel material.

The motor’s operating temperature is 0 to 40°C (32 - 104°F) while the storage temperature requirement is 0 to 50°C (32 - 122°F) both with relative humidity requirement of 5-95% non-condensing.

It has a standard flange connection and its shaft is made of stainless steel. This device has long-life bearings and a higher tolerance design than other servo motors. The Allen-Bradley N-3412-2-H00AA also draws very little current, resulting in higher efficiency and lower heat production. The speed output of the motor is 6000 RPM. The rotor moment of inertia for this motor is 0.00015 kg-m2. It has 4 poles. The operating relative humidity range for this motor is 5 to 95%. Always keep in mind to store this device in dry locations with ambient temperatures of less than 50 degrees Celsius (122 degrees Fahrenheit). The operating temperature range for the device is 0 to 40 degrees Celsius (32 to 104 degrees Fahrenheit). Allow sufficient space around this servo motor to keep it within the operating temperature range. When mounting the couplings to the motor shaft, be sure that they are properly aligned with the load inside of the specification limits. The operators can use the 0041-5065 shaft seal kit to increase the protection rating of the device to IP65. The Allen-Bradley N-3412-2-H00AA has dimensions of 88.4 millimeters x 88.4 millimeters x 169.42 millimeters (3.48 inches x 3.48 inches x 6.67 inches). The item's approximate weight is 3.5 kilograms (7.7 pounds).