5810TER

The 5810TER is an Ethernet Terminator that is manufactured by Allen-Bradley and classified under the pyramid integrator AB series of Allen-Bradley parts. The 5810TER comes with PI modules that are packaged in bags, helping in the protection of the modules from any possible electrostatic damage. The 5810TER should be stored in a static-safe environment while unpacking the module, setting the jumpers inside the module and when placing the side panel on the module. Note that performing an operation on the 5810TER incorrectly might cause an electrostatic discharge to occur damaging the module. The internal operations need to be performed only in an environment that provides safety from static environments.

Before mounting the 5810TER, it is important that the users first check out the mounting documentation and gather the PI components, the tools, and the supplies and consider the rack mounting the components. In addition, it is important that the users ensure they gather all the tools and the equipment when necessary. The PI components needed when mounting the 5810TER includes a 4-slot chassis, an industrial disk, a distribution panel, the I/O board for vision, and also the I/O chassis and the power supply. For installation, the users also require installation screws, a wrench set, a wire brush, and also a tape measure. While mounting the I/O board, it is important that the users attach the I/O interface box to the I/O board and attach it to the mounting surface. Also, attach the interface box to the top of the I/O board and attach to the mounting surface. Ensure that the scraped surface of the enclosure wall is in contact with the total surface area of the ring terminal.