IC200PNS002

The GE Fanuc Versamax IC200PNS002 PROFINET Scanner (PNS) Module requires the Proficy Machine Edition software that is version 7.0 or later and an RX3i PLC central processing unit with firmware version 7.0 or later. The module has 2 SC-Duplex connection ports rated at 100 Mbps. The Versamax PROFINET Scanner LEDs include the power supply LEDs which are the "PWR1" and "PWR2" LEDs and which glow solid green when on. The "OK" LED turns solid green when the module is operating normally. The "OK" LED for other modules is usually off or flashes when there is a power-up failure or a machine error, and if the scanner is not set up to restart automatically, the "OK" LED will flash amber. The "FAULT" LED shows the status of the Versamax node. The LED is usually off if there is no PROFINET diagnosis on the PROFINET scanner module or the modules in the node. If there is a diagnosis condition, the "FAULT" LED glows solid amber.

The GE Fanuc Versamax IC200PNS002 PROFINET Scanner (PNS) Module also has a "CONNECT" LED that flashes amber when the unit powers up to show that it is not ready to use. Later, it turns solid green to show that the unit has established communication with the primary I/O controller. When the IC200PNS002 Scanner Module is updating the firmware, the "CONNECT" LED flashes amber rapidly to indicate that all connections are blocked. The "LAN" LED flashes to indicate that the scanner is loading Ethernet packets and it turns off when there are no activities. The IC200PNS002 Scanner Module has a temperature range of 0 to 60 degrees Celsius for normal operation and dimensions of 132 millimeters (5.2 inches) in height and 134 millimeters (5.28 inches) in width.