AG62

An essential part of the MELSEC-A series, the Mitsubishi AG62 fake module is made to aid in the creation of an extensive MELSEC-A controller system. The AG62 dummy module is essential for maintaining the integrity of vacant slots in a MELSEC-A controller system. The AG62 dummy module is deployed to guard against potential damage from foreign particles when a controller system has an extension base unit with open slots that are not hosting active modules. By fitting into an extension base unit, this module effectively protects the space it takes up from potential pollutants including dirt, dust, and debris. It is vital to remember that the AG62 dummy module should be left in place until it is necessary to swap it out with another module. This module, which is compatible with Mitsubishi QA65B and QA68B extension base units, provides a protective barrier to preserve the cleanliness and efficiency of the system. The AG62 fake module must be handled gently to ensure its functionality, avoiding any rough impacts or drops that can potentially compromise its case or connectors. When utilising M4 fastening screws, it's crucial to use the proper screw torque during installation, which falls between the range of 78 and 118 N-cm. Although the AG62 fake module can offer some protection against brief exposure to moisture, it is not made to survive prolonged exposure to water or other liquids that might cause damage, including injury to the slot and its connectors. In the MELSEC-A series, the Mitsubishi AG62 dummy module essentially acts as a valuable protective component, protecting open slots and connections from impurities and minimal moisture exposure to ensure their longevity and performance.