Search Results
1928 results
IC660BLC003
GE Fanuc Emerson / Genius I-O
This prefabricated cable features mating connectors and operates using the Genius Serial Bus communication protocol. Its terminating plug is rated at 150 Ohms. Designed to function effectively within a temperature range of 0 degrees Celsius to 40 degrees Celsius, this cable can sustain up to 80% hum
IC660EBA020
GE Fanuc Emerson / Genius I-O
The GE Fanuc IC660EBA020 Genius I/O Analog Block Electronics Assembly is made for the Genius I/O IC66BBA020 Voltage/Current Analog Block. This I/O block electronics assembly has 4 analog inputs, 2 analog outputs, 18 to 56 Volts DC of operating voltage, and 8.0 Watts of output power.
IC693PCM300
GE Fanuc Emerson / Series 90-30
Designed for placement on the CPU baseplate, this module facilitates communication with terminals and CRT displays. The IC693PCM300 supports protocols such as Modbus RTU and GE Fanuc CCM. It includes a lithium battery to ensure RAM memory retention during power outages, alongside programming capabil
IC694MDL634
GE Fanuc Emerson / RX3i PacSystem
The GE Fanuc IC694MDL634 Module from the RX3i PacSystem series is an input module that is made to be installed in any I/O slot in the RX3i system. The module has a rated voltage of 24 Volts DC with positive or negative logic.
IC694TBC032
GE Fanuc Emerson / RX3i PacSystem
This terminal block is structured with a shielded cable connector type, ensuring minimal interference in communication setups. Designed to operate within temperatures ranging from 0 °C to 60 °C, it maintains performance reliability across these conditions. It has been tested for installation at alti
IC610MDL182
GE Fanuc Emerson / Series One
The IC610MDL182 output module features 16 relay outputs, with output voltage capabilities ranging from 5 to 220 volts AC and 5 to 30 volts DC. It is mounted vertically in a single rack slot and is compatible with Series One PLCs. This module includes LED indicators for status monitoring and utilizes
IC693CBK003
GE Fanuc Emerson / Series 90-30
The GE Fanuc Automation IC693CBK003 cable kit comes with 2 cables with a 24-pin connector on each. Each one of these 24 pins or conduits has a current rating of 1.2 Amps.
IC600YB813
GE Fanuc Emerson / Series Six
This input module is accurate within ±1.3 °C and features a resolution of 13 bits. Cold junction compensation and open thermocouple detection are included. Users can adjust the sample rate via jumpers, and the module maintains a normal mode rejection of 86 dB at line frequencies. Calibration should
IC600YB921
GE Fanuc Emerson / Series Six
This output module features 32 TTL output points, each with an individual LED indicator for monitoring status. It supports DIP switch configuration within the PLC's CPU output table and includes options for circuit board jumper configurations, which allow for inversion, disabling, or holding the las
IC610MDL101
GE Fanuc Emerson / Series One
This input module supports eight sink inputs and does not require an external power supply. The maximum voltage rating reaches up to 36 volts DC, with an input impedance of 1.8 kilohms. The on-state level is maintained below 3 volts DC, while off-state levels exceed 3 volts DC. LED indicators are in