Search Results
1928 results
IC610MDL157
GE Fanuc Emerson / Series One
This output module operates within a 5 to 24 VDC voltage range, with a peak voltage capability of 40 VDC. The removable terminal block simplifies installation and maintenance. The typical on-state voltage drop is 1 Volt DC, rising to a maximum of 2 Volts DC at full load. The leakage current is measu
IC697MDL241
GE Fanuc Emerson / Series 90-70
The GE Fanuc IC697MDL241 Discrete Input Module is manufactured as part of the Series 90-70 product line. This module has an operating voltage of 240 Volts AC and it comes with 16 isolated input points. It also has an input filter time of 20 milliseconds and it is compatible with the proximity switch
IC200ALG265
GE Fanuc Emerson / Versamax
The GE Fanuc Automation IC200ALG265 analog input module from the Versamax series. It comes with an input current of 4 to 20 milliamps and an input impedance of 100k Ohms.
IC670CBL002
GE Fanuc Emerson / Field Control
Rated for use in operating frequencies from 50 to 60 Hertz, this cable can handle voltages of either 115 Volts AC or 24 Volts DC. It includes 20 pins and incorporates a braided drain wire that provides effective electrostatic protection. Installation is suitable up to 1,000 meters without requiring
IC754ACC64MEM
GE Fanuc Emerson / QuickPanel+
This GE Fanuc Emerson memory card is designed to support up to four devices or integrated circuits. It operates at 3V DC and offers a bus width of 32 bits with a minimum bus speed of 100 MHz, allowing efficient data transfer. The module has a maximum refresh cycle time of 64 milliseconds and does no
IC660BLM506
GE Fanuc Emerson / Genius I-O
The IC660BLM506 plug is a terminating plug with a 150-Ohm resistance rating. This device is installed in the Serial 1 and Serial 2 terminals for bus termination on the Genius I-O blocks.
IC660BBA025
GE Fanuc Emerson / Genius I-O
The IC660BBA025 Current-Source Output Block is a 6-output analog current-source block from GE Fanuc. It has 24 to 48 Volts DC of block power, 1500 Volts of block to block isolation, and 12 Watts of heat dissipation.
IC200UDR040
GE Fanuc Emerson / Versamax
The IC200UDR040 is a programmable logic controller (PLC) from the GE Fanuc Emerson Versamax series, specifically designed as a 40-point device. It features 24 digital inputs that operate on a 24V DC power supply. The controller includes 16 outputs utilizing normally open relay configurations and acc
IC600BF942
GE Fanuc Emerson / Series Six
This module features an operating voltage range of -10 to 10 volts, providing versatility in signaling applications. It allows for 29 units of load at 5V DC, while showing no load capability at 12V DC or -12V DC. The faceplate is sized at 317 x 30 mm (12.4 x 1.1 in.), and is designed to operate effe
IC695CEP001
GE Fanuc Emerson / RX3i PacSystem
The IC695CEP001 CEP carrier component is manufactured by GE Fanuc and it is made for a voltage range of 19.2 to 30 Volts DC and it has a power rating of 5.25 Watts (0.22 Amps) at 24 Volts DC. This PROFINET CEP carrier has 2 Ethernet RJ-45 ports and a Micro-B USB port for firmware.